![]() The method I use I is that when I find one edge I make a small pencil mark on the wall then repeat for the other edge. For anything heavy it is better to find the edges of the stud by making a series of exploratory probes with an 8d finish nail (6d in drywall). In most cases It locates the nail but the nail but the nail may be way off the stud center line. Tap the walla lot, moving back and fortharound 16 inches (the stud may be a little less than 16 inches from the corner, especially if you have an older house, when stud spacing wasn’t necessarily standard). Use a tape measure and mark 16 inches and 24 inches from the corner. When you can detect something with the stud finder, use the earth magnet to locate the stud by. For lath and plaster walls, without metal mesh reinforcements, you may be able to use a metal finder by detecting the nail heads that attach the wooden lath to the studs. Here’s how: Go to the corner of the room. Use a metal stud finder to locate the stud, but it’s pretty much difficult to get the result, because of the horizontal strips and plaster. Lath-and-plaster wall surfaces are trickier than drywall. Where the studs are, you have the same plaster and laths, and then 4 or 6 inches of solid wood. Studs are like wood battens that support the walls and hold the weight. If you’ve got an instant stud finder like the Franklin Sensors T6, you can skip all of the sweeping and just move the stud finder around until you see a clear three-light indicator that indicates the position and rough size of a stud. Here’s a better method without a stud finder. Bosch’s Professional Stud Finder is far from the cheapest, but if you’re looking for a fully. F inding a stud behind plaster and lath is hit-or-miss with a typical stud finder. ![]() Bosch Professional Stud Finder: Best stud finder. Even though plaster walls have laths, the area behind that is open, for wiring, plumbing, and insulation. The best stud finders you can buy in 2024. ![]() The hanging method is great on plaster walls or even marble if the magnet is strong enough, however if the magnet is too strong you lose resolution.Īnother drawback to any magnetic stud finder is that while it will find nails (& EMT, galvanized pipe, metal ducts, steel Studs, metal mesh lath, etc) it does not locate the ℄ of the stud. This seemingly silly practice is actually a very accurate way to find studs in walls. Cow magnets have the magnetic strength concentrated around the center of the magnet rather than at the ends so that sharp metal fragments ingested into a cow's stomach will stick to the center section of the magnet rather than the ends where it might do further damage.Ī cheaper alternative is to use a small rare earth magnet or an old magnet from a computer hard drive and super glue it to a string. ![]() Your small magnet suggestion is also used commercially in a new stud finder that uses a cow magnet suspended from a chain. Very cool and also at a reasonable price. Click to expand.J Bird, Welcome to the Forum and congratulations on your finding that Amazon Link. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |